2-Step Steering Speed - Proton 2 Channel FM Radio Control System User Manual

2-Step Steering Speed (Servo Speed)
This feature becomes available under the heading of Servo Speed when the
programming level in the Pit Mode is set to Advanced. 2-Step Steering Speed is
similar to the Steering Speed found under the Intermediate Level, But it adds speed
change points. You can adjust the steering servo's speed moving away from the
center (turning) and back to the center (returning) independently, but you can also
set speed charge points in both directions independently. You can then assign
individual speed values for each segment as illustrated in the graph below. To
program;
1. Press button until the cursor is at Servo speed.
2. Press button to display the Servo Speed screen as shown below.
3. Press / button until the desired value appears on Steering turn Low-side.
4. Press to confirm the new value or
5. Press and repeat steps 3 & 4 to program the rest of the parameters as listed in
the example below.
6. Press to return to the Circuit Mode.
Circuit mode
EPA
Response
Start / Idle up
DBA
[ Servo speed ]
St turn L
C.P
St turn H
ST retn L
C.P
St retn H
Servo speed
ABS
SST
80%
45
75%
60%
50
45%
Data Setting & Programming
[Advanced Level]
to cancel and retain previous value.
100%
80%
75%
turn speed
60%
45%
return speed
0
Neutral 45 50
change point
27
Right / Left