National Instruments SCXI-1100 User Manual page 119

D*/A signal
description of, 3-5, C-3
equivalent to DAQD*/A signal, 3-6
DAQD*/A signal
description of, 2-23, B-2
register selection and write procedure,
5-2 to 5-3
SCXIbus equivalent, 3-6
selecting slots, 2-26 to 2-29
DIG GND signal
description of, 2-23, B-2
digital I/O line specifications and
ratings, 2-25
digital control circuitry
Configuration Register, 3-8
illustration, 3-8
Module ID Register, 3-8 to 3-9
digital I/O signal connections
data acquisition board pin
equivalences, 2-25
digital input signals, 2-24 to 2-25
digital output signals, 2-24 to 2-25
digital timing signals, 2-25
emulation of communication
signals, 2-24
specifications and ratings, 2-25
digital interface circuitry, 3-7
digital signal connections, 2-3 to 2-5
jumper settings (illustration), 2-5
jumper W5, 2-3 to 2-4
jumper W9, 2-4
jumper W11, 2-4 to 2-5
documentation
conventions used in manual, xii
organization of manual, xi to xii
related documentation, xiii
DTEMP signal, 2-13, D-2
E
equipment, optional, 1-3
F
fax technical support, G-1
FIFO (First-In-First-Out) memory chip, 3-14
FIFO Register
description of, 4-9
writing to registers, 5-1
filtering specifications, A-2
FOUTEN* bit, 4-5
front connector
AC-coupled connection, 2-15
analog input channels, 2-13 to 2-16
© National Instruments Corporation
analog output, 2-17
connector-and-shell assembly,
2-17 to 2-18
exceeding maximum ratings (warning),
2-11, 2-16
floating signal connection, 2-14
ground-referenced signal
connections, 2-14
open thermocouple detection, 2-17
pin assignments, 2-12, D-1
signal connection descriptions, D-2
signal descriptions, 2-13
terminal block, 2-19 to 2-21
thermocouple connections, 2-16
FRT bit, 4-8
G
gain error at DC, specifications, A-2
GAIN<4..0> bit, 4-3 to 4-4
GUARD signal, 2-13, 3-5, C-3, D-2
H
hardscan circuitry, programming,
5-10 to 5-11
Hardscan Control Register
description of, 4-8
writing to registers, 5-1
hardware. See also cabling.
custom cables, 1-4
installation, 2-10 to 2-11
optional equipment, 1-3
unpacking, 1-4
HSRS* bit, 4-8
I
initialization of registers, 5-3
input filtering, 2-9 to 2-10
input protection specifications, A-2
installation
capacitors and resistors, 2-10
hardware installation, 2-10 to 2-11
terminal block, 2-20
unpacking, 1-4
instrumentation amplifier
analog and timing circuitry, 3-11
specifications, A-1
INTR* signal
buffering of SLOT0SEL* line, 2-3
description of, 3-5, C-3
equivalent to SLOTSEL* signal, 3-6
Index-3
Index
SCXI-1100 User Manual