Honda H6522 Owner's Manual page 107

n
Battery cleaning
If the battery terminals are contaminated or corroded, remove the battery
and clean the terminals.
Removal:
1. Open the engine hood and remove the hood (see page 39).
2. Remove battery hold down.
3. Disconnect the negative (-1 battery cable first, then disconnect the
positive (+I battery cable.
4. Remove the battery.
5. Clean the terminals with a wire brush or sand paper. Clean the battery
with a solution of baking soda and warm water, taking care not to get
the solution of water in the battery cells. Dry the battery thoroughly.
Clean the battery cable ends with a wire brush or sand paper.
EGATIVE I-1 TERMINAL
BATTERY HOLD DOWN
Installation:
1. Install the battery into the tractor.
2. Connect the positive (+) battery cable first and tighten the nut securely.
Slide the battery boot over the positive (+) cable and terminal.
3. Connect the negative (-1 battery cable. Tighten the nut securely.
4. Coat the battery terminals and cable ends with clean grease.
5. Reinstall the battery hold down.
6. Reinstall the engine hood (see page 39).
105