Honda H1000 Series Operator's Manual page 7

3. Temporarily install the cover plate on the
two
mower deck, using
4. Hold swirl guide B against the cover plate.
Insert a pencil through the holes in swirl guide
B to mark drilling points on the cover plate.
Remove the cover plate from the mower deck.
Center punch and drill the cover plate at the
pencil marks.
Use an 11/32 inch (8.4
eye protection when drilling.
Remove any burrs from the holes.
SWIRL GUIDE B HOLES
8 mm lock nuts.
COVER PLATE
8.7 mm) drill. Wear
DEALER INSTALLATION INSTRUCTIONS
1.
Install the cover plate on the mower deck,
5.
using two 8 mm lock nuts.
Attach swirl guide B to the cover plate, using
two 8 x 35 mm flange bolts,
and 8 mm lock nuts.
Install the bolts from inside the mower deck.
Install the nuts outside the mower deck. Use
washers on both sides, as shown.
Tighten all 8 mm nuts and bolts to a torque
value of 15.2 ft-lb (2.1 kg-m).
m m
8 LOCK
6. Place swirl guide A in the mower deck, with
one end against swirl guide B.
While holding swirl guide A in place, drill the
first hole in the mower deck, using the hole in
swirl guide A as a drill guide.
Use a 1/4 inch (6.2
protection when drilling.
Remove any burrs from the hole.
8 mm flat washers,
SWIRL GUIDE B
FANGE BOLT
COVER PLATE
6.4 mm) drill. Wear eye
3