Honda H1000 Series Operator's Manual page 9

12. Install the mulching blade, using the original
blade holder and hardware.
Be sure the blade is positioned right side up
(outer edges turn toward the mower deck). If
the blade is installed upside down, it cannot
cut properly.
The blade bolts are specially designed for this
application and must not be replaced with any
other bolts.
Use a wooden block to prevent the blade from
turning when tightening the bolts.
Tighten the 10 x 28 mm flange bolt to a torque
value of 36.2 ft-lb
(5.0
Tighten the 12 x
25
torque value of 61.5 ft-lb
BLADE WASHER
MULCHING
BLADE
BLADE HOLDER B
I
kg-m).
mm flange bolts to a
kg-m).
(8.5
FLANGE BOLT
FLANGE BOLT
1. DEALER INSTALLATION INSTRUCTIONS
5