ProForm LX 360 User Manual page 7

6. Hold the Console (43) near the Console Base (47).
the Right Handrail (72) to discharge any static. Plug
the widest connector on the Wire Harness (42) into the
widest connector on the Console. If the connector does
not fit easily, rotate it and then connect it. Plug the other
connector on the Wire Harness into the other connector on
the Console. Insert the excess Wire Harness down through
the opening in the Console Base (see the inset drawing
in step 5). Securely tighten the plastic tie on top of
the Console Base to prevent the Wire Harness from
slipping. Then, cut off the end of the plastic tie.
Refer to drawing 6a. Press the Bookrack (46) onto the
Console Base (47) in the location shown.
Set the Console (43) on the Console Base (47). Insert
the excess Wire Harness (42) into the large hole in the
side of the Right Handrail (72). Securely tighten the
plastic ties on the bottom of the Console Base to
prevent the Wire Harness from slipping. Then, cut off
the ends of the plastic ties.
Attach the Console (43) to the Console Base (47) with two
1/2" Silver Screws (49) and four 3/4" Screws (2). Start all
six Screws before tightening them; do not over-
tighten the Screws.
7. Attach the Latch Spacer (48) and the Storage Latch (36)
to the left Handrail (71) with two 1" Latch Screws (110).
Remove the Lock Knob (30) from the Lock Pin (35).
Make sure that the Lock Pin Collar (33) and the Spring
(32) are on the Lock Pin. Insert the Lock Pin into the
Storage Latch (36) and tighten the Lock Knob back onto
the Lock Pin.
8. Attach a Wheel (66) to the inner side of the Base (69)
with a Wheel Bolt (64) and a Nut (13) as shown.
overtighten the Wheel Bolt. The Wheel should be able
to spin freely.
Attach a Wheel (66) to the other side of the Base (69) in
the same way.
Lower the Handrails (not shown) to the floor. Make sure
that the frame is centered between the Handrails. Firmly
tighten all of the bolts and screws used in assembly
steps 3–6. Then, raise the Handrails.
9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 14). To protect the floor or carpet, place a mat under the treadmill.
Touch
6
Ties
6a
47
7
71
8
Do not
7
42
43
2
49
72
46
110
30
36
33
48
32
69
13
66
64
47
2
35