Installing The Antenna Modules; Removing The Camera - Dell OptiPlex 9010 Owner's Manual

m) power supply unit
n) heat-sink assembly
o) power-supply fan
p) system board
3. Remove the screws that secure the antenna module to the chassis. Unthread the antenna cable from around the
edges of the computer. Lift and remove the antenna module.

Installing the Antenna Modules

1. Place the antenna module on the chassis.
2. Thread the antenna cable around the edges of the computer. Tighten the screws to secure the antenna module to
the chassis
3. Install:
a) system board
b) power-supply fan
c) heat-sink assembly
d) power supply unit
e) processor fan
f) converter board
g) power-button board
h) intrusion switch
i) hard drive
j) optical drive
k) WLAN card
l) input/output board shield
m) system-board shield
n) VESA mount bracket
o) back cover
p) VESA stand
4. Follow the procedures in

Removing the Camera

1. Follow the procedures in
2. Remove the:
42
After Working Inside Your Computer .
Before Working Inside Your Computer .