Installing The Vesa Mount Bracket; Removing The Touchscreen Board - Dell OptiPlex 9010 Owner's Manual

Installing the VESA Mount Bracket

1. Align and place the bracket on the back of the computer.
2. Tighten the screws to secure the VESA mount bracket to the computer.
3. Install the:
a) back cover
b) VESA stand
4. Follow the procedures in

Removing the Touchscreen Board

1. Follow the procedures in
2. Remove the:
a) VESA stand
b) back cover
c) VESA mount bracket
3. Press the sides of the touchscreen-board shield to release the notches securing it to the chassis and remove the
touchscreen-board shield from the chassis. Disconnect the system-board cable from the touchscreen-board cable
connector. Lift the connector latch and disconnect the touchscreen-board cables from the touchscreen board.
4. Remove the screws that secure the touchscreen board to the chassis. Lift up and remove the touchscreen board
from the chassis.
After Working Inside Your Computer .
Before Working Inside Your Computer .
15