D-Link AirPlus DI-714P+ Manual page 24

Using the Configuration Menu
Advanced > IP Filter
Use IP (Internet Protocol) filters to allow or deny computers access to the Internet based
on their IP address. IP filters apply both to wired computers connected to one of the four
Ethernet LAN ports and also to wireless clients connected wirelessly to the DI-714P+.
Disabled IP Filter-
Allow all computers to access the Internet except those listed below-
Deny all computers access to the Internet except those listed below-
Start Source IP -
End Source IP-
Start Port -
End Port-
Enable-
Select this option if you do not want to use MAC filters.
Select this option to allow computers that are in the list to
access the Internet. All other computers will be denied access
to the Internet.
Select this option to deny computers that are in the list to
access the Internet. All other computers will be allowed ac-
cess to the Internet.
Enter in the IP address range of the computers that you want
the policy to apply to. If it is only a single computer that you
want the policy applied to, then enter the IP address of that
computer in the Start Source IP and leave the End Source IP
blank.
Enter in the port range of the TCP/UDP ports that you want the
policy to apply to. If it is only a single port that you want the
policy applied to, then enter the port number in the Start Port
field and leave the End Port field blank. If you want to use all
the ports, you can leave the port range empty.
Select this option for the specific IP filter policy to take effect.
24