Setting The Number Of Rings; Toll Saver; Recording Outgoing Messages (Ogm) - Radio Shack TAD-724 Owner's Manual

43-724A.fm Page 16 Tuesday, May 16, 2000 4:51 PM
Note: You must enter your selec-
tion within 10 seconds after the
TAD announces the day of the
week, hour and minute. Other-
wise, the current selection aborts
and the TAD exits the program
mode. If this happens, start over.
3. Press or
SKIP REPEAT
the day. The TAD announces the
day of the week each time you
press the button.
4. Press to store the day of the
TIME
week you set.
5. Repeat Steps 3 and 4 to store the
hour and the minute.
6. When you press
TIME
the minute, the TAD beeps and
announces the current day, hour,
and minute.
Notes:
The TAD uses the 12-hour time
format. Be sure to set the correct
AM or PM hour.
To hear the current day of the
week and time, press
SETTING THE NUMBER
OF RINGS
The TAD is preset to ring twice before
it answers the first call. To have it ring
2, 4, or 7 times before answering,
slide (located on the
RING SELECT
back of the TAD) to ,
2
16
the TAD ring 2, 4, or 7 times before
answering a call).

TOLL SAVER

To help you avoid unnecessary long
distance charges, you can slide
to adjust
SELECT
select
the TAD answers on the second ring.
If there are no new messages, the
TAD answers on the fourth ring, and
gives you time to hang up before it an-
swers.
RECORDING OUTGOING
after setting
MESSAGES (OGM)
You can record three different OGM
types to fit your needs.
Note: The TAD has a built-in outgoing
message that says, "Hello, please
leave your message after the tone."
This built-in OGM is available for
OGM 1 and OGM 2 only.
.
TIME
, or ( to have
4 7
to (Toll Saver). Once you
TS
, if there are new messages,
TS
1. Slide
ANNOUNCE
(located on the back of the TAD)
to for OGM 1),
1 ( 2
(for Announce Only).
AO
RING
SELECT
(for OGM 2), or