Honda Accord xl 2007 Fit Owner's Manual page 191

０５／１２／２１ １７：００：１５ ３１ＳＡＡ６００ ０１９０
HOLD-DOWN
WIRE BULB
RUBBER WEATHER SEAL
3. Remove the electrical connector
from the bulb by pulling the
connector straight back.
4. Remove the rubber weather seal
by pulling on the tab.
5. Unclip the end of the hold-down
wire from its slot. Pivot the wire
out of the way, then remove the
bulb.
6. Install the new bulb into the hole,
ELECTRICAL
making sure the tabs are in their
CONNECTOR
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
INSPECTION WINDOW
7. Make sure that the hold-down
wire is installed properly and
securely. You can check its
installation from the inspection
window on the headlight assembly.
8. Install the rubber seal over the
back of the headlight assembly.
9. Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
HOLD-DOWN headlights to test the new bulb.
WIRE
10. Reinstall the inner fender cover.
Then reinstall the holding clip, and
lock it in place by pushing on its
center.
Lights
187