Honda Accord xl 2007 Fit Owner's Manual page 110

０５／１２／２１ １６：５０：３０ ３１ＳＡＡ６００ ０１０９
Playing the AM/FM Radio
To Play the AM/FM Radio
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob or the AM/FM
button (AM or FM button except
Sport model). Adjust the volume by
turning the same knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button (AM or FM button). On the
FM band, ST will be displayed if the
station is broadcasting in stereo.
Stereo reproduction in AM is not
available.
To Select a Station
You can use any of five methods to
find radio stations on the selected
band: tune, seek, scan, the preset
buttons, and auto select.
106
TUNE Use the TUNE bar to tune
−
to a desired frequency. Press the
side of the bar to tune to a
higher frequency, and the
to tune to a lower frequency.
The seek function
SEEK −
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the or side of the
SEEK bar, then release it.
SCAN − The scan function samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
The system will scan for a station
with a strong signal. When it finds
one, it will stop and play that station
for about 10 seconds.
If you do nothing, the system will
then scan for the next strong station
and play it for 10 seconds. When it
side plays a station you want to listen to,
press the SCAN button again.
Each preset button
PRESET −
(1 6) can store one station on AM,
−
and two stations on FM.
1. Select the desired band, AM or
FM. FM1 and FM2 let you store
twelve stations.
2. Use the tune, seek, or scan
function to tune the radio to a
desired station.
3. Pick a preset number (1 6), and
hold it until you hear a beep.
4. Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
−