Table of Contents
Advertisement
VIVOTEK
You can click Restore to recall the original settings without incorporating the changes. When
completed with the settings on this page, click Save to enable the settings.
If you want to configure another sensor setting for day/night/schedule mode, (namely, for a
particular lighting condition for a specific period of time), please click Profile to open the Profile of
exposure settings page as shown below.
Activated period: Select the mode this profile to apply to: Day mode, Night mode, or Schedule
mode. Please manually enter a range of time if you choose Schedule mode. Then check Save to
take effect.
Please follow the steps below to setup a profile:
1. Check Enable this profile.
2. Select the applied mode: Day mode, Night mode,
or Schedule mode. Please manually enter a range
of time if you choose Schedule mode.
3. Configure Exposure control settings in the folowing
columns. Please refer to previous dicussions for
detailed information.
4. Click Save to enable the setting and click Close to
exit the page.
50 - User's Manual
Advertisement
Table of Contents
