Broom Replacement - Honda FS7054 Operator's Manual

BROOM REPLACEMENT

Whenever the broom becomes excessively tapered,
worn past the service limit or sweeping is difficult,
replacement is necessary.
Broom Removal
1. Make sure the engine is turned off, the ignition key is removed, and the spark plug cap(s) are
disconnected.
2. Use the sweeper lift crank to raise the broom until it is just slightly off the ground.
3. Remove the drive chain retaining clip, and remove the master link from the drive chain. The retaining
clip can get bent or damaged during removal, so never reuse the clip. Always install a new master link
during assembly.
4. Unbolt the two pillow block bearings from the sweeper hood by removing the four 3/8-16 inch carriage
bolts.
Use the sweeper lift crank to raise the sweeper hood above the broom assembly. Roll the broom
5.
assembly out from under the sweeper hood.
3/8-16" C ARRIA G E
BOLT (4)
FS7054 SWEEPER
3/8" NUT (4)
MAINTENANCE & ADJUSTMENTS
SERVICE LI M IT
1/2 inch
21