Honda FS7054 Operator's Manual page 24

Broom Assembly
1. Slide on a brush then a wafer spacer. Align
brush tabs with the opening in the tri-core center.
Rotate the wafer spacer overlap areas and brush
tabs every 120" on the tri-core center.
2. Install 4 or 5 brushes and wafer spacers, then
push them all down and install 4 or 5- m ore.
3. Install the end plate using three 1/4-20 inch bolts
and washers. Before tightening the bolts, make
sure the top brush tabs are aligned with the
tri-core center.
4. Install the pillow block bearing so the bearing is
flush with the shaft end and/or the set screws
reseat into their original indentations in the shaft.
Apply 2 drops of HONDA LOCK 2 P/N
0871 3-0002 to the set screw threads and torque
the set screws to 9.6 N•m (85 in-lb).
5. Roll the broom assembly under the sweeper
hood, and lower the hood down onto the pillow
block bearings.
6. Install and tighten the pillow block bearing
carriage bolts.
7. Raise the broom. Install the drive chain using a
new master link. Install the master link retaining
clip with the closed end toward the rotation
direction as shown below.
FS7054 SWEEPER
MAINTENANCE & ADJUSTMENTS
'
START WITH A BRUSH
BRUSH
TABS ARE
120" APART
WAFER SPACERS
ARE 120" APART
23