Mb Intelligent Bios Iii) Menu - ECS A75F2-A2 V1.0 User Manual

M.I.B III (MB Intelligent BIOS III) Menu
This page enables you to set the clock speed and system bus for your system. The
clock speed and system bus are determined by the kind of processor you have
installed in your system.
Main
Core clock multiplier
Memory Clock
Memory Timing Configuration
Memory Clock DCT0 is:
Command Rate
CAS# Latency (tCL) :
RAS# to CAS# Delay (tRCD)
Row Precharge Time (tRP)
RAS# Active Time (tRAS)
Memory Clock DCT1 is:
Command Rate
CAS# Latency (tCL) :
RAS# to CAS# Delay (tRCD)
Row Precharge Time (tRP)
RAS# Active Time (tRAS)
SB Spread Spectrum
CPU Over-clocking Func.
Spread Spectrum
IGD Over-clocking Func.
IGD Frequency
CPU Voltage
DIMM Voltage
NB Voltage
FCH Voltage
Core clock multiplier
This item is used to set Core clock multiplier.
Memory Clock
This item is used to set memory clock.
Memory Timing Configuration
This item shows the information of Memory Timing.
CAS Latency (tCL)
This item determines the operation of DDR SDRAM memory CAS (colulmn address
strobe). It is recommended that you leave this item at the default value. The 2T
setting requires faster memory that specifically supports this mode.
RAS# to CAS# Delay (tRCD)
This item specifies the RAS# to CAS# delay to Rd/Wr command to the same bank.
Row Precharge Time (tRP)
This item specifies Row precharge to Active or Auto-Refresh of the same bank.
RAS# Active Time (tRAS)
This item specifies the RAS# active time.
42
Advanced Chipset
A75F2-A2 USER MANUAL
M.I.B III Boot
Enabled/Disabled IGD
Auto
Over-clocking Func.
Auto
Auto
None
N/A
N/A
N/A
N/A
N/A
(DDR-1600/800Mhz)
2 T
9 CLK
9 CLK
10 CLK
28 CLK
Enabled
Enter/Dbl Click : Select
Disabled
Disabled
+/- : Change Opt.
Enabled
F1: General Help
800
F2: Previous Values
Default
F3: Optimized Defaults
Default
Default
F4: Save & Exit
1.21V
ESC/Right Click: Exit
Security Save & Exit
: Select Screen
/Click: Select Item