System Initialization; Si-300Cc Opening Screen - TDK VCS-04 User Manual

SI-300CC to Computer
Connect the SI-300CC to a control computer using an IEEE-488 cable (not supplied).
S4
Power Supply
SI-300CC The SI-300CC is equipped with a universal input AC power supply that can
operate from a wide range of input AC power allowing it to be used internationally without
any jumper settings. The allowable input voltage rating is 100-240 VAC, 50-60Hz.
Connect the power cable to an approved grounded outlet.
S5
Video Monitor The video monitor is equipped with an AC power supply. Verify that the
input connector is compatible with your power supply.
Connect the power cable to an approved grounded outlet. If the connector is not compatible
with your power supply, add the appropriate adapter and connect to an approved grounded
outlet.
VC-04 The power module is mounted on top of the VC-04 via a 4-pin LEMO connector. The
VC-04 has two options for power – AC and DC.
1. AC Module: Universal input 100-240VAC, 50-60Hz.
Connect the power cable to an approved grounded outlet.
V1
2. DC Module: 12V 4A Ni-MH Rechargeable Battery module. The battery module must be
removed for recharging. Use only the charger that is supplied with the camera system.
These modules are interchangeable. The unit has a RED power LED that will illuminate if
the unit is powered on.

System Initialization

SI-300CC Opening Screen

After powering on the remote cameras, you should observe the opening screen shown below
with the device name, company name, and IEEE 488 address.
TDK RF Solutions
Video Camera System User Manual 8