Connecting The Cables; Connecting The Power Supply - BIXOLON STP-131 User Manual

2. Connecting the cables

NOTE
※
Before connecting any of the cables, make sure that both the printer and the host are
turned off.

2-1 Connecting the Power Supply

※ CAUTION
When connecting or disconnecting the power supply from the printer, make sure that the
power supply is not plugged into an electrical outlet. Otherwise you may damage the
power supply or the printer.
If the power supply's rated voltage and your outlet's voltage do not match, contact your
dealer for assistance. Do not plug in the power cord. Otherwise, you may damage the
power supply or the printer.
- Make sure that the Printer's power switch is turned off, and the power supply's power
cord is unplugged from the electrical outlet.
- Check the label on the power supply to make sure that the voltage required by the power
supply matches that of your electrical outlet.
- Plug in the power supply's Adapter cable as shown below. Notice that the flat side of the
plug faces down.
NOTE
※
To remove the DC cable connector grasp the connector at the arrow and pull it straight out.
Make sure that the main unit's power cord is unplugged before you disconnect the DC
cable connector
Rev. 1.04
Adapter Cable
- 9 -
Power Connector
STP-131