Fujitsu fi-4340C Operator's Manual page 69

1 Setting Multi feed detection (Paper Thickness)
When you set the use of Multi feed detection, you must set it as follows:
1. Press or
Screen 1
!
=
2. At Screen 1.
Press either the or
(transmitted light).
The paper thickness is checked using the difference between two consecutive sheets of paper fed
from the ADF. On this screen, select whether or not to check for Multi feeding, and select the error
processing.
Each time either of these buttons is pressed, the location of the blinking moves. When the
pressed, the blinking moves from (1) to (3). When the
opposite direction. However, if the setting by the host computer is valid, the location of the blinking
does not move when either button is pressed.
(1) "No" is blinking: Paper thickness is not checked.
(2) "Yes" and "1" are blinking: Paper thickness is checked. However, a detected Multi feed error is
displayed on the screen only; processing is continued.
(3) "Yes" and "2: Stop" are blinking: Paper thickness is checked. When the Multi feed error is
detected, the scan processing is stopped. The error is then reported to the host.
If you want to disable the Multi feed, select "No" then press
NOTICES
1. Multi Feed detection might have better results when both the paper thickness and the paper length
are used.
2. When the document in ADF is not the Multi fed document, the previous document might be Multi fed,
in case the scanner stops feeding by using the Multi feed detection.
3. Depending on the type of printing on the document, a Multi feed may not be detected by the paper
thickness.
and let the scanner display Screen 1.
0 1 M u l t
N o / Y e s
button to set the Multi feed detection according to the paper thickness
i F e e d
1 / 2 : S t o
button is pressed, the blinking moves in the
. Press
p
button is
to return.
● 7 - 5