Door Removal Instructions; Getting Through Narrow Spaces - Frigidaire 242134903 Use & Care Manual

Getting through narrow spaces

If your refrigerator will not fit through an entrance area,
you can remove the doors. Check first by measuring the
entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is unplugged
from the wall outlet.
2 Open the freezer drawer and remove the toe grille
(see "Installation" section).
3 Remove any food from the door shelves and close
the doors.
To remove the top hinge covers:
1 Remove the two (2) screws from each cover over
the top door hinges.
2 Lift inside edge of hinge cover and tilt back.

NOTE
DO NOT remove the ground screw from hinge.

DOOR REMOVAL INSTRUCTIONS

To remove the refrigerator doors:
1 Trace lightly around the door's top hinges with a
pencil. This makes reinstallation easier.
2 Disconnect the harness by grasping both sides of the
connector firmly, depress the latch, and pull apart.
Remove the two (2) screws from the top hinge. Lift
the door off of the bottom hinge and set it aside.
3 Detach the water tube from the connector
located behind the refrigerator and pull the tube
back out to the front of the unit. The connector
releases when you press inward on the outer
sleeve while pushing the tube toward the connector
then while continuing to hold in the sleeve, pull the
tube away.

NOTE
Use care while pulling the water tube from the unit to
be sure that you do not kink the tube.
5
9