Storage Preparation; Cleaning; Engine; Pump - Honda WDP30X Owner's Manual

STORAGE
STORAGE PREPARATION
The following steps will help to keep rust and corrosion from
impairing your pump's function and appearance, and will make the
engine easier to start when you use the pump again.
Cleaning
Engine
Wash the engine by hand, and be careful to prevent water from
entering the air cleaner or muffler.
1 NOTICE 1
l
Using a garden hose or pressure washing equipment can force
water into the air cleaner. Water in the air cleaner will soak the
filter and can enter the carburetor or engine, causing damage.
l
Water contacting a hot engine can cause damage. If the engine
has been running, allow it to cool for at least half an hour before
washing.
Pump
1. Flush the pump chamber (see page 43).
2. Wash the pump with a garden hose or other low pressure
equipment. Keep water away from controls, and all other places
that are difficult to dry, as water may promote rust.
3. After washing: Remove as much .standing water as possible with a
dry cloth. Start the engine outdoors and let it run until it reaches
normal operating temperature to evaporate any water remaining on
the engine.
4. Stop the engine, and allow it to cool.
5. After the pump is clean and dry, touch up any damaged paint, and
coat other areas that may rust with a light film of oil. Lubricate
controls with a silicone spray lubricant.
56