Regulatory Tests And Certifications - Olorin VistaLine VL127D User Manual

Regulatory Tests and Certifications

All Olorin products have normally been tested to comply with all mandatory Regulatory
requirements for the markets where the products are sold. Approvals are listed by each
Regulatory Agency under the name of the manufacturer and model number as specified on the
Product Identification Label. Copies of such approvals can be requested by contacting Olorin AB
via www.olorin.com.
Approvals applicable for this product is listed in the Product Specification section of this
manual.
Tests and Approvals for VistaLine Series
Each product in the VistaLine series has been tested as an IT-category product for normal office
environment and for use as a desktop monitor. They comply with the following standards and
regulations:
• CE for use within the European Union member states
• UL for use in the United States
• FCC for use in the United States
• WEEE for use within the European Union member states
• RoHS for use within the European Union member states
Tests and Approvals for MedicLine Series
Each product in the MedicLine series has additionally been tested for risk of electrical shock and
to comply with
• MDD directive 93/42/EEC class 1 for the European Union member states
• EN60601-1, EN60601-1-2
• IEC 60601-1
Some of the products have also been tested to comply with:
• UL 60601-1
• CAN/CSA C22-2 No. 601-1
Under these directives and regulations, MedicLine products are complying with the requirements
for a Class 1 product with continuous mode of operation. The monitor must not be in direct contact
with a patient.
Using any other 12V/24V adapter than the medical approved one delivered with the
product or connecting this to a non-grounded power outlet voids the approval.
Warning
Before taking the product in use, the person installing it must test that the grounding
of the monitor complies with the impedance requirements of the country where it is
being installed.
Warning
When using at 240 V in the United States, supply must be from center-tapped, 240 V,
single phase circuit.
Warning
10