Lindy 3 Port User Manual

3 Port HDMI Switch
User Manual
LINDY No. 38033
www.lindy.com
Product Information
Front Panel:
Connect your HDMI sources to one of the 3 input ports
Rear Panel:
Connect your HDTV to the output port
This switch has an optional PSU port. If your HDMI ports, on your source
device do not support power over HDMI then you will need to use an
appropriate power supply. Please contact LINDY if you require this.
Side Panel:
Connect the IR receiver extension cable to this port
Introduction
Thank you for purchasing the LINDY 3 Port HDMI Switch. This switch
allows you to connect three HDMI devices to a single HDMI equipped TV
or projector and then switch between them using a push button or
remote control.
The maximum recommended cable transmission distance is a total of
30m from the source to the display. This can be made up with 15m from
the source to the switch and 15m from the switch to the display. Longer
distances may be possible but this does depend on the quality of the
source, the display and the connecting cables. We recommend you use
LINDY Premium Gold cables for the best possible performance.
The HDMI Switch also supports DVI-D signals when used with
English
appropriate DVI-D to HDMI adapters or DVI-D to HDMI cables.
Features
• HDMI 1.3b, HDCP 1.1 and DVI 1.0 compatible
• LED channel selection indicators
• 12-bit deep colour
• Ideal for home theatre integration, presentation, conference
rooms and retail stores
• Supports high resolution input:
• PC: Up to 1920 x 1200
• HDTV: Up to 1080p
• Easy to install and simple to operate
• Input source auto detects when an active source is connected
Package Contents
• LINDY 3 Port HDMI Switch
• Infra-red remote
• IR receiver extension cable
• This User Manual
Connection and Operation
1. Connect the HDMI cables from your source devices to the HDMI
Input ports 1, 2 & 3
2. Connect an HDMI cable from your display (monitor or projector) into
the HDMI Output port on the switch
3. Select the desired input as follows:
Manual Switching
On the top panel, press the Select button until the desired input is
selected. Each press will cycle to the next input in turn: 1-2-3 then back
to 1. The current input can be identified by the LED on the switch.
From the remote control
Plug the IR extender cable into the switch and then select the input you
require from the remote control.
Notes on using DVI equipped devices:
To connect DVI equipped devices you can use either modular
DVI/HDMI adapters or DVI/HDMI adapter cables. Be aware that DVI
is a 'video only' interface; audio signals are not supported when
using DVI source devices. Also, please note that DVI equipped
displays must support HDCP signal decoding to display HDCP
protected HDMI signals. HDCP compatible displays will normally
feature the HD Ready logo.
Technical Information
• Frequency bandwidth: 2.5Gbps
• Inputs: 3 x HDMI Female ports (Type A connector)
• Output: 1 x HDMI Female port (Type A connector)
• Dimensions: 80 x 57 x 18mm (WxDxH)