Subscribe to Our Youtube Channel
Related Manuals for DeLonghi RADIANT HEATER WITH TERMOSTAT
Summary of Contents for DeLonghi RADIANT HEATER WITH TERMOSTAT
- Page 1 21-07-2003 16:05 Pagina 1 RADIANT HEA TER WITH TERMOST RADIANT HEA TER WITH TERMOST TERMOST TILLA V ARUSTETTU TERMOST TILLA V ARUSTETTU INFRAPUNALÄMMITIN INFRAPUNALÄMMITIN...
- Page 2 21-07-2003 16:05 Pagina 2 RADIANT HEATER WITH TERMOSTAT Technical Data Type Category Maximum Medium Gas pressure Input Input Input see rating label 4.20 2,85 1,50 28÷30 mbar This appliance is designed to operate with Butane, propane or mix LPG at nominal pressure: 28 ÷...
- Page 3 21-07-2003 16:05 Pagina 3 ASSEMBLY 1) Remove the polystyrene fixing the heater base plate Tabs B Holes A and the heater front panel. Remove the heater base plate from the polystyrene. Place the heater base plate on the floor or on a flat surface.
- Page 4 21-07-2003 16:05 Pagina 4 GENERAL SAFETY INSTRUCTIONS Gas bottle Gas Bottle with 15 kg of maximum capacity can be installed. Changing of gas bottle must not be carried out in the presence of a naked flame. Use the gas bottle always in upright position. If a screw on regulator is used ensure that the regulator washer is present and in good condition -replace if in any doubt.
- Page 5 21-07-2003 16:05 Pagina 5 OPERATING INSTRUCTIONS Lighting the heater 1. Open the gas bottle tap. 2. Fully depress the large knob on the valve for 10 seconds and then turn it 90° to the right or left to activate the piezoelectric starter (if the pilot flame does not ignite return the knob to the initial position and repeat the operation).
Need help?
Do you have a question about the RADIANT HEATER WITH TERMOSTAT and is the answer not in the manual?
Questions and answers