Advertisement
GB
21-07-2003
16:05
1) Remove the polystyrene fixing the heater base plate
and the heater front panel.
Remove the heater base plate from the polystyrene.
Place the heater base plate on the floor or on a flat
surface.
Remove the two screws from the holes "A" (fig.5).
2) Position the heater's front panel assembly over the
base plate, and align the four tabs "B" on the base with the four slots "C" (fig.6) in the
bottom of the front panel assembly. With the four tabs correctly engaged,
push the front panel assembly forwards as far as the tabs will slide in their
slots to align the screw holes "A" in the base plate with the screw holes "D"
in the bottom of the front panel assembly.
3) Fit the front panel assembly to the base plate by fixing the two screws (fig.7) (removed
previously) trough the aligned screw holes (holes D and A).
Place the gas cylinder in the gas cylinder compartment and connect the regulator to the
cylinder as shown on page 4.
Screw
fig. 7
4) Finally, fit the flexible rear panel. First,
engage the two clips located on the top
cover, in order to bend the panel and fix
it into shape. Then insert the six tabs in
the six slots at the rear of the heater body
Attention: to unhook press on the rele-
vant clips (fig.8).
Pagina 3
ASSEMBLY
Top
cover
Tabs B
Holes A
fig. 5
Tabs B
fig. 6
Slot C
clip
Lower
cover
Top
Clip
cover
Tabs
Lower
cover
Tabs
Holes D
fig. 8
3
Advertisement
