Advertisement
Models without remote control on
handgrip:
Turn the power regulation knob on the
appliance (fig. 14).
CLEANING
Replacing the remote control batteries (cer-
tain models only)
If the remote control commands do not
work, you must replace the batteries. Open
the cover of the compartment (fig. 15) and
replace the batteries with the same type.
EPS (Electronic Protection System) dust bag
full indicator
The indicator lights up when the vacuum
duct is blocked or the dust bag is full. When
it comes on (fig. 16A), replace the bag. In
models with remote control, all three indi-
cator lights on the power regulator (fig. 16B)
come on to show that the system is activa-
ted.
If you continue to use the appliance after the
indicator has come on, the vacuum power is
reduced automatically. This is a safety devi-
ce to avoid damage to the motor.
Once the cause leading the EPS system to
intervene has been removed, turn the
appliance off then on again by pressing the
pedal
. This is the only way to turn the
appliance back on.
Replacing the dust bag
To change the paper dust bag, pull the bag
compartment opening lever (fig. 17) and lift
the cover. Remove the bag holder (fig. 18).
Place the bag holder over a rubbish bin,
close the bag by pulling the tab on the card-
board (fig. 19) and drop it into the bin.
Replace with a new bag, put the bag holder
back and close the dust bag compartment
again exerting light pressure.
To guarantee vacuuming efficiency and
exploit the full capacity of the bags, use
bags authorised by the manufacturer only.
14
You should change the dust bag frequently
when vacuuming up very fine dirt such as
flour, talcum powder, etc.
NB:
The appliance has a safety device which
prevents the dust bag compartment cover
being closed when there is no dust bag in
place.
Motor protection filter
To extend the working life of the appliance
and protect the motor, it is vital to keep the
motor protection filter clean. To access the
filter, open the dust bag compartment,
extract the dust bag and remove the filter
(fig. 20). If the filter is not excessively dirty,
simply remove the dust. If the filter is very
dirty, wash and dry.
Make sure the filter is perfectly dry before
replacing it. Make sure it is positioned cor-
rectly.
Air outlet filter
Your appliance is fitted with a high effi-
ciency filter (HEPA Filter**)
This is housed under the air outlet slits.
To replace, press and lift the grille (fig. 21).
Remove the filter.
Replace the filter by resting it in position
then close the grill, exerting light pressure
until the clips click into place.
You should replace the filter at least every
five dust bags changes.
**
The HEPA Filter (High Efficiency Particulate Air)
removes impurities down to a size of 0.3 microns,
filtering all types of particle and even bacteria.
Advertisement
