Advertisement
ASSEMBLY INSTRUCTIONS
Hose
Attach the connector to the coupling and
push in until it locks into place (fig. 1).
To remove, press the release button on the
connector and pull out (fig. 2).
Telescopic tube (different according to
model)
Attach the telescopic tube to the handgrip
(fig. 3). The telescopic tube extends to the
required length (fig. 4).
Tool holder (Fig. 5)
The tool holder on your appliance enables
you to keep the smallest tools close at hand.
After attaching the tools to the tool holder,
hook the tool holder to the hose near the
handgrip.
USING THE CLEANING TOOLS
• Two position carpet/floor brush
Attach to the telescopic tube (fig. 6)
Efficiently removes dust from floors
(marble or tiled), rugs or carpets.
When the "hard floors" pedal (
(fig. 7) is pushed, the bristles protru-
de to clean hard floors more effi-
ciently. This position is recommended
for in-depth cleaning and floors with
pronounced joints. When the "car-
pets" pedal (
the bristles retract and the brush is
ready to clean fabric surfaces or
vacuum up coarse dirt (e.g. large
breadcrumbs) which would otherwi-
se be trapped in the bristles of the
brush.
• Crevice tool (Fig. 9)
to clean radiators, corners, edges, dra-
wers, etc. Fit onto the telescopic tube or
handgrip and push as far as it will go.
• Multipurpose nozzle (fig. 10)
To clean upholstered furniture, mattres-
ses, garments, car seats etc.
) (fig. 8) is pushed,
• Parquet brush
This special brush has soft natural horse-
hair bristles and felt wheels which run
over even the most delicate floor without
damaging it, leaving it perfectly clean
INSTRUCTIONS
Before using the appliance, extract the
power cable completely and plug into the
mains. To rewind the cable, unplug and
press the cable wind pedal
Operation
To turn the vacuum cleaner on and off,
lightly press the pedal switch
Models with remote control on handgrip:
While cleaning, you can also interrupt
vacuuming by pressing the
button on the remote control. To resume
cleaning, press one of the power regulation
buttons (+ or -).
NB: the
does not turn the appliance off. To turn off,
press the pedal switch
Electronic suction power regulation
)
The electronic regulator enables suction
power to be varied according to the type of
surface to be cleaned.
The maximum power of the appliance can
therefore be exploited to vacuum dust from
carpets or hard floors (marble, ceramics,
cotto, etc) and a lower suction power to
clean curtains or other light fabrics.
Models with remote control on handgrip:
Press buttons "+" and "-" on the appliance
or remote control unit (fig. 13) to choose the
power level. The corresponding LED lights
up (MIN, MED, MAX).
NB: the power can also be regulated with
the batteries flat by using the buttons on the
appliance.
button interrupts vacuuming but
.
(fig. 11) .
(fig. 12).
"StopVac"
13
Advertisement
