Automatic Operation - Hitachi RAS-18CP5 Instruction Manual

AUTOMATIC OPERATION

The device will automatically determine the mode of operation COOL, or Dehumidify, depending on the
initial room temperature. The selected mode of operation will not change when the room temperature
varies.
RESET
CONDITION OF AUTOMATIC OPERATION
The selected mode of operation will not change during the operation even though the room temperature
change.
INITIAL ROOM
TEMPERATURE (APPROX.)
Over 27 C
16~27 C
Press the FUNCTION selector so that the display indicates
the (AUTO) mode of operation.
1
When AUTO has been selected, the device will
automatically determine the mode of operation COOL or
Dehumidify, depending on the initial room temperature
and outdoor temperature.
Press the
START
Operation starts with a beep.
STOP
Press the button again to stop operation.
As the settings are stored in memory in the remote controller, you
only have to press the
You can raise or lower the temperature setting as necessary by
maximum of 3 C.
C
The preset temperature and the actual room temperature may
vary somewhat depending on conditions.
The display does not indicate the preset temperature in the
AUTO mode. If you change the setting, the indoor unit will
produce a beep.
FUNCTION
COOL
Slightly lower than the
DEHUMIDIFY
room temperature
– 7 –
(START/STOP) button.
(START/STOP) button next time.
Press the temperature button and the
temperature setting will change by 1 C each
time.
TEMPERATURE
SETTING
27 C
FAN SPEED
HIGH at start, LOW after
the preset temperature is
reached.
LOW