INDOOR UNIT INDICATORS
OPERATION INDICATOR
TEMPORARY SWITCH
Use this switch to start and stop when the remote controller does not work. [Use non-conductor stick
(example: toothpick)]
By pressing the temporary switch, the operation is done in previously set operation mode.
●
When the operation is done using the temporary switch after the power source is turned off and turn
●
on again, the operation is done in automatic mode.
FILTER LAMP
When the device is operated for a total of about 200
hours, the FILTER lamp lights to indicate that it is
time to clean the À lter. The lamp goes out when the
"
(AUTO SWING)" button is pressed while the
device is on "STANDBY MODE".
OPERATION LAMP
This lamp lights during operation.
The OPERATION LAMP Á ashes in the following cases
during heating.
(1) During preheating
For about 2 ~ 3 minutes after starting up.
(2) During defrosting
Defrosting will be performed about once an hour
when frost forms on the heat exchanger of the
outdoor unit, for 5~10 minutes each time.
TIMER LAMP
This lamp lights when the timer is working.
●
This À gure shows the opening condition of
front panel. Refer to page 19 in relation to
how to open or close the front panel.
– 5 –