Operation Indicator - Hitachi RAS-D10CDK Instruction Manual

ATTACHING AND REMOVING FRONT PANEL
RECEIVABLE INDICATOR FUNCTIONS
Temporary Switch

OPERATION INDICATOR

TEMPORARY SWITCH
When the remote control device is not functioning, use the Temporary Switch mode
(1) When the Temporary Switch is pressed, the unit will operate as per the previous setting.
() Press the Temporary Switch a second time will stop the operations of the air conditioner unit.
AUTO RESTART FUNCTION
In the event of power failure, the air conditioner will restart automatically.
In the event of power failure during TIMER operation, the timer will be reset and the unit will begin or stop
operating under a new timer setting.
• While gripping both the left and right hand edges
[recessed in the front housing] of the front panel,
lift up to open the front panel.
• After completion of job, slightly lift up the front
panel and pull down to close the front panel. Ensure
that the  sets of left, centre and right clips are
fully secured.
Operation Lamp (YELLOW)
This lamp lights during operation.The lamp
flashes when the defrosting is functioning in
"heating" mode or at the time the pre-heating is
operating in  to  minutes.
Timer Lamp (ORANGE)
This lamp lights when the timer is working.
The lamp flashes periodically when any
abnormality occurs in the indoor unit.
-  -