Auto 3In1 - Siemens Dishwasher Instructions For Use Manual

en

auto 3in1

The use of so-called combined detergent
products may make the use of rinse aid
and/or salt unnecessary.
There are currently several types of
combined detergent products available.
3in1: They contain detergent, rinse aid
and salt function.
2in1: They contain detergent and rinse
aid or salt function.
>>> Always check the type of detergent
or combined product which you
are using!
Always follow the operating instructions
or the information on the packaging.
The rinse programme is automatically
adjusted in order to obtain the best
possible rinsing and drying result.
Observe the following important
information if using combined cleaning
products:
Regeneration salt is not required up to
a water hardness of 21_ dH (37_ fH,
26_ Clarke, 3.7 mmol/l) only. No other
settings on the appliance are required.
Salt is still required if the water
hardness is above 21_ dH (37_ fH,
26_Clarke, 3.7 mmol/l). Fill the salt
dispenser with salt
setting 6 on the water softening system.
If in doubt, please contact the detergent
manufacturer, especially if:
the utensils are very wet at the end
of the programme.
limescale forms.
16
and select
24
Note
Optimum rinsing and drying results can be
obtained by using standard detergents in
conjunction with separate application of
salt and rinse aid.
Observance of the operating instructions
or information on the packaging of the
combined detergents determines their
effectiveness.
Note
Even if the rinse aid and/or salt refill
indicator is lit, the rinse programme runs
correctly when 3in1 products are used.
If the rinse aid refill indicator
refill indicator is defective and you
6
would like to switch it off, proceed as
follows:
Switching the rinse-aid refill
indicator off or on*
*
some models
You can switch off the rinse-aid refill
indicator if you use a detergent
7
with integrated rinse-aid.
Close the door.
Press and hold down button A .
Press main switch
display lights up.
Release both buttons.
The digital display
(rinse-aid refill indicator) and the button
A flashes.
By pressing button A you can switch
the rinse-aid indicator off
Switch off the main switch
The setting is saved.
"Remember to switch on the rinse-aid refill
indicator again if you use a detergent
without an integrated rinse-aid!"
or salt
7
until the digital
1
indicates
8
or on .
;
1