Fireplace Insert Installation; Operation; Battery Replacement; Resetting The Temperature Cutoff Switch - Dimplex ELECTRIC FIREPLACE User Manual

FIREPLACE INSERT INSTALLATION

1. Make sure the units MAIN ON/OFF switch is switched OFF (refer to operating
instruction section).
2. Plug the unit into a 15Amp/120volt outlet. If the cord does not reach, you may use an
extension cord rated for a minimum of 1875 watts.
3. Push the fireplace into the opening being careful not to damage the base of the mantel
or cabinet so that the fireplace is flush with the mantel or cabinet.
4. Level the unit with shims if necessary (not provided).
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp edge and
ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the
risk of fire, electric shock or injury to persons.

OPERATION

The fireplace is supplied with an integrated on/off
remote control.
Note: Ensure that the fireplace 3 position switch is set to
the remote control setting.
To operate, push the ON button to turn fireplace on, push the
OFF button to turn the fireplace off.

BATTERY REPLACEMENT

To replace the battery, slide battery cover open on the hand
held transmitter.
Correctly install one 12 volt (A23) battery in the battery holder.
Close the batter cover.

Resetting the temperature cutoff switch

The heater is protected with a safety device to prevent overheating. Should the heater
overheat, an automatic cut out will turn the heater off and it will not come back on without
being reset. It can be reset by switching the ON/OFF SWITCH to OFF and waiting 5
minutes before switching the unit back on.
Caution
If you need to continuously reset the heater, unplug the unit and call your local dealer.
www.sylvane.com 1-800-934-9194
MANUAL
OPERATION
ON BUTTON
BATTERY
OFF
REMOTE
CONTROL
OFF BUTTON
BATTERY
COVER
MAIN THREE
POSITION ON
OFF SWITCH
HEAT
SWITCH
THERMOSTAT
5