Installation - Panasonic DBS 824 Manual

Section 320 dbs 824 to dbs interconnection

Hide thumbs Also See for DBS 824:

Installation

1. Set SW1 on the CBL-M card according to the following table.

Table 3.

CBL-M switch settings

Master

DBS 40

DBS 72

DBS 96

2. Install the circuit cards according to the layouts shown in the Figures 1

Note: The port numbers for each slot are fixed.

3. Using the cables provided, connect the CBL-M card in the master cabinet

4. Connect the green ground lead on each of the DBS cables to a side frame

Section 320 - DBS 824 to DBS Interconnection Supplement

System

Combinations

Slave

DBS 824

OFF ON

through 3.

to the CBL-S card installed in the slave cabinet. The cables should be

connected with the green ground cables located at the CBL-M card.

Note: The EMI filter must be installed as close to the cabinet as possible,

as shown in Figure 4 on page 7.

screw on the DBS cabinet.

DBS Manual - Revised April 2000

Switch

Settings

ON ON

OFF ON

ON ON

OFF ON

ON OFF OFF OFF

OFF ON

OFF OFF

DBS-2.3/9.2-320

Dbs