Carrying Handle; Operation - Delta 20-140 Instruction Manual

CARRYING HANDLE

When transporting the machine, the cuttinghead should
always be locked in the down position by means of the
holddown chain (A) Fig. 18. A carrying handle (B) is pro-
vided for ease of transportation.
After clamping the workpiece securely in the vise, turn
the machine on and allow the motor to come up to full
speed. Lower the wheel (A) lightly until it comes into
contact with the workpiece (B), as shown in Fig. 19. Do
not allow the wheel to chatter and jump as this may
cause the wheel to wear out of round, resulting in poor
quality cutting and possible broken wheels.
Continue to push firmly down on the handle while the
cut is being made, as shown in Fig. 20
When coming through the bottom of the cut, as shown
in Fig. 21, do not slow up. This keeps the metal from
overheating and dragging off in a heavy burr.

OPERATION

10
B
Fig. 18
Fig. 19
Fig. 20
Fig. 21
A
A
B