Homelite UT10942D Operator's Manual page 23

6. Lay out the saw chain in a loop and straighten any
kinks. The cutters should face in the direction of chain
rotation. If they face backwards, turn the loop over.
7. Place the chain drive links into the bar groove as
shown in figure 46.
8. Position the chain so there is a loop at the back of the
bar.
9. Hold the chain in position on the bar and place the loop
around the sprocket.
10. Fit the bar flush against the mounting surface so that
the bar studs are in the long slot of the bar.
Note for UT10942D: When placing the bar on the bar
studs ensure that the adjusting pin is in the chain
tension pin hole.
11. Replace the outer guide bar plate ensuring that the bar
pin groove is at the bottom with the upper and lower
edges angled away from the guide bar.
12. Replace the clutch cover and bar mounting nuts.
13. Tighten the bar mounting nuts finger tight only. The
bar must be free to move for tension adjustment.
CHAIN DRIVE LINKS
MAINTENANCE
CUTTERS
CHAIN ROTATION
Fig. 44
Fig. 45
CHAIN DRIVE LINKS
ADJUSTING PIN
FOR UT10942D
Page 23
BAR STUDS
GUIDE BAR
PLATE
MOUNTING
SPROCKET
CLUTCH
COVER
BAR
GROOVE
Fig. 46
BAR
NUTS
Fig. 47