Homelite UT10942D Operator's Manual page 13

CHOKE LEVER
7. When the temperature is above 50° F, pull the
STARTER GRIP until the engine attempts to start, but
no more than 3 times. When the temperature is below
50° F, pull the STARTER GRIP until the engine
attempts to start, but no more than 5 times.
8. Push CHOKE lever all the way IN. See Figure 18.
9. Pull the STARTER GRIP until engine runs.
Note: Allow the saw to run in this position 15-30
seconds depending upon the temperature.
10. SQUEEZE and release the throttle trigger to return the
engine to idle.
CAUTION:
Failure to release partial throttle when chain brake
lever is in the brake position will result in serious
damage to the unit. Never squeeze and hold the
throttle trigger while the chain brake is in the brake
position.
THROTTLE TRIGGER
OPERATION
Fig. 18
TRIGGER
RELEASE
Fig. 19
Page 13
Now you are ready to pick up the saw. Use the proper
grip for both handles, refer to "Operation" for additional
information.
STOPPING THE ENGINE
See Figures 20 and 21.
Release the throttle trigger and let the engine return to
idle. To stop the engine, move the Ignition Switch to the
" O " stop position. Do not put the chain saw on the
ground when the chain is still moving. For additional
safety, set the chain brake when the saw is not in use.
In the event that the Ignition Switch will not stop the saw,
pull the choke lever out to the fully extended position (See
Figure 17) and engage chain brake to stop the engine.
If the Ignition Switch will not stop the saw when set to the
stop " O " position, have the Ignition Switch repaired
before using the chain saw again to prevent unsafe
conditions or serious injury.
Important: When you are finished using the saw, relieve
tank pressures by loosening the CHAIN OIL and FUEL
MIX caps. Then retighten the caps. Allow the engine to
cool before storing.
IGNITION SWITCH
IN THE STOP
POSITION
BRAKE POSITION
Fig. 20
Fig. 21