Maintenance - Homelite UT10942D Operator's Manual

ASSEMBLING THE BAR AND CHAIN
See Figures 41 through 51.
DANGER:
Never start the engine before installing the guide bar,
chain, drivecase cover, and clutch drum. Without all
these parts in place, the clutch can fly off or explode
exposing the user to possible serious injury.
WARNING:
To avoid serious personal injury, read and
understand all the safety instructions in this section.
1. Always place the Ignition Switch in the stop "O"
position before you work on the saw.
2. Make sure the chain brake is not set by pulling the
chain brake lever/hand guard towards the front handle
to the RUN position.
3. Wear gloves when handling the chain and bar. These
components are sharp and may contain burrs.
4. Remove the bar mounting nuts using a combination
wrench or 5/8 in. wrench.
5. Remove the clutch cover, and the outer guide bar plate.

MAINTENANCE

RUN POSITION
Fig. 41
Page 22
COMBINATION
WRENCH
BAR MOUNTING NUTS
GUIDE BAR
PLATE
BAR MOUNTING NUTS
Fig. 42
CLUTCH
COVER
Fig. 43