Homelite UT10942D Operator's Manual page 12

STARTING THE ENGINE
See Figures 13 through 19.
WARNING:
Keep your body to the left of the chain line. Never
straddle the saw or chain, or lean over past the
chain line.
1. Place the chain saw on level ground and ensure that no
objects or obstructions are in the immediate vicinity that
could come in contact with the bar and chain.
2. Hold the front handle firmly with the left hand and put
your right foot onto the base of the rear handle.
IGNITION SWITCH
IN THE RUN
POSITION
OPERATION
3. Set the Ignition Switch to the RUN (I) position.
4. Make sure the chain brake is in the RUN position by
5. Fully press and release the PRIMER BULB 7 times.
6. Pull CHOKE lever all the way OUT to full position. The
STARTER
GRIP
Fig. 13
Fig. 14
Page 12
pulling back on the lever / hand guard. See Figure 15.
partial throttle position is automatically set when the
choke lever is set at full choke.
RUN POSITION
PRIMER BULB
CHOKE LEVER
Fig. 15
Fig. 16
Fig. 17