Display Panel; Opening The Display Panel; Using The System As A Tablet - Fujitsu LifeBook P Series Manual

L i f e B o o k P S e r i e s N o t e b o o k - S e c t i o n T w o
Latch
Latch Slot

Display Panel

The convertible design of your LifeBook P Series note-
book allows you to open the display fully, rotate it 180
degrees, and lay it face up on the keyboard. This allows
you to use the system as a tablet, much as you would a
pad of paper.

OPENING THE DISPLAY PANEL

Lift the display cover backwards, being careful not to
touch the screen, until it is at a comfortable viewing
angle. (Figure 2-10)

USING THE SYSTEM AS A TABLET

If you would like to use the system as a tablet, perform
the following step
s.
Rotate the system display only in the
direction indicated in the procedure.
Turning the display in the incorrect
direction could damage the hinge.
In the following step, be sure to position
the display perpendicular to the keyboard,
otherwise the keyboard or display cover
could get scratched.
1. Lift the display until it is perpendicular to the
keyboard. (Figure 2-12).
2. When the display is perpendicular to the keyboard,
rotate it clockwise (when viewed from the top). Be
very careful to rotate it in the direction indicated.
(Figure 2-13). Turn the display 180 degrees so that it
is facing backwards. (Figure 2-14)
3. Holding the top edge of the display panel, pull it
forward until it is lying nearly atop the keyboard.
16
Figure 2-10. Opening the display
4. Push the latch towards the display (See "A" in
Figure 2-11). The latch will click twice and the top
latch disappears, and the bottom latch appears (See
"B" in Figure 2-11). Lay the display flush against the
system so that the latch rests in the slot in the battery
pack. You can now use the system as a tablet.
(Figure 2-15)
Top latch
Bottom latch
5. To return the system to notebook configuration,
repeat step 3 and 2. Be sure to turn the display in the
opposite direction when performing step 2.
Display Cover
A
B
Figure 2-11. Using the Display Latch
Display Side