Upgrading/Exchanging Main Memory - Fujitsu PRIMERGY RX800 S2 Options Manual

Upgrading/exchanging main memory

5.2 Upgrading/exchanging main memory
Ê Follow the instructions in
Ê If an already built-in memory card is concerned, remove it as described in
the Operating Manual (open retention levers etc.).
Ê Place the memory card on a flat, static-protective surface with the DIMM
connectors facing up.
Ê Open the retaining clips on each end of the DIMM connector (see
V
CAUTION!
To avoid breaking the DIMM retaining clips or damaging the DIMM
connectors, open and close the clips gently.
Ê If an existing DIMM is to be replaced, gently pull it out of the connector.
DIMM
Figure 10: Removing a DIMM
Ê Touch the static-protective package that contains the DIMM to any unpainted
metal surface on the server. Then, remove the DIMM from the package.
28
chapter "Preparation" on page
Main memory
19ff.
figure 10).
Retaining
clip