Advertisement
d AUDIO OUT (Left/Right) Connect to a TV with audio inputs. e COMPONENT VIDEO OUT/PROGRESSIVE SCAN (Pr Pb Y) Connect to a TV with Pr Pb Y
OUT Passes the signal from the AERIAL to your TV/monitor g OPTICAL IN Connector Connect an optical output of Digital Device. h SYSTEM Connect the
SPEAKER SYSTEM at the Active Speaker. l m n o i S-VIDEO OUT (DVD OUT) Connect to an S-Video Input on TV. j VIDEO IN 1 Connect the video output
of an external source (Audio system, TV/Monitor, VCR, Camcorder). k VIDEO OUT Connect to a TV with video inputs.
l VIDEO OUTPUT Switch Select either COMPONENT VIDEO OUT/ PROGRESSIVE SCAN or RGB signal of EURO AV1 AUDIO/VIDEO terminal
depending on how you connect the recorder to the TV. m EURO AV 1 AUDIO/VIDEO Connect to a TV with SCART jack. n EURO AV 2 DECODER Connect
the audio/video output of an external source (Pay-TV decoder, Set Top Box, VCR, etc.). o HDMI Connector (Type A) HDMI output providing a high quality
interface for digital audio and video. Connecting to the Aerial Remove the aerial cable plug from your TV set and insert it into the aerial socket at the back of
the recorder. Plug one end of the aerial cable into the TV socket on the recorder and the other end into the aerial input socket on your TV set. Aerial Rear of
TV SCART INPUT ANTENNA INPUT AUDIO INPUT VIDEO INPUT L R R RF coaxial connection Connect the RF. OUT jack on the DVD Recorder
Receiver to the aerial input jack on the TV using the 75ohm Coaxial Cable supplied (R). The RF.
OUT jack passes the signal through from the AERIAL jack. Rear of the HDD/DVD Recorder Receiver 11 Hookup and Settings Connections to Your TV Make
one of the following connections, depending on the capabilities of your existing equipment. When using the Pr Pb Y jacks, set the VIDEO OUTPUT switch to
COMPONENT. When using the SCART jack, set the VIDEO OUTPUT switch to RGB. Tips Depending on your TV and other equipment you wish to connect,
there are various ways you could connect the recorder. Use only one of the connections described below. Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the best connections. Caution Make sure the recorder is connected directly to the TV. Tune the TV to the correct
video input channel. Do not connect the recorder's AUDIO OUT jack to the phono in jack (record deck) of your audio system.
Do not connect your recorder via your VCR. The DVD image could be distorted by the copy protection system. Rear of TV SCART INPUT S-VIDEO INPUT
VIDEO INPUT AUDIO INPUT COMPONENT VIDEO INPUT Video connection Connect the VIDEO OUT jack on the recorder to the video in jack on the TV
using the video cable (V). Audio (Left/Right) Connection Connect the left and right AUDIO OUT jacks of the recorder to the audio left and right IN jacks on
the TV using the audio cables (A). Do not connect the recorder's AUDIO OUT jack to the phono in jack (record deck) of your audio system.
Component Video connection Connect the Pr Pb Y jacks on the recorder to the corresponding input jacks on the TV using an Y Pb Pr cable (C). Progressive
Scan connection If your television is a high-definition or "digital ready" television, you may take advantage of the recorder's progressive scan output for the
highest video resolution possible. If your TV does not accept the Progressive Scan format, the picture will appear scrambled if you try Progressive Scan on
the recorder. Connect the Pr Pb Y jacks on the recorder to the corresponding in jacks on the TV using the Y Pb Pr cable (C). Notes: Set the Progressive to
Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack) or S-VIDEO connection. Caution Once the setting for
Progressive Scan output is entered, an image will only be visible on a Progressive Scan compatible TV or monitor. If you set Progressive Scan to ON in error,
inputs. f RF.
[ON] on the setup menu for progressive signal, see page 25.
you must reset the recorder.
Advertisement
