Advertisement
Cause The disc was recorded in Video mode. Some players will not play even a finalized disc recorded in Video mode. The disc was recorded in VR mode,
Discs recorded with copy-once material cannot be played on other players. No solution. Solution Finalize the disc. (page 30) The other player must be RW
Use another disc. You cannot record the source. Select the channel on the recorder's built-in TV tuner. Use a VR mode formatted disc for copy-once material.
Set clock to correct time. See "Clock Set" on page 24. Reprogram Timer. See "Timer Recording" on page 48. Reprogram Timer. No solution.
No solution. Make A/V connections. Stereo is available only via A/V output from the recorder. Select AUX or A/V source as TV input. Set TV audio channel
See "Changing TV audio channel" on page 47. Point the remote control at the remote sensor of the recorder. Operate the remote control within 7 m. Remove
Cannot record or did not record successfully. The remaining blank space on the disc is insufficient. The source you are trying to record is copy protected.
When setting the recording channel, the channel is tuned on the TV's own tuner. When recording to a Video mode disc, programs that are copy-once protected
cannot be recorded. Timer recording is not possible. Clock in recorder is not set to correct time. Timer has been programmed incorrectly. Timer record
indicator light does not appear after programming timer. Stereo Audio Record and/or Playback is not present.
TV is not Stereo-compatible. Broadcast program is not in stereo format. The recorder A/V Out jacks are not connected to TV A/V In jacks. The recorder
Audio/Video Out is not selected for viewing at the TV. The recorder's TV audio channel is set to mono. The remote control does not work properly. The remote
control is not pointed at the remote sensor of the recorder. The remote control is too far from the recorder. There is an obstacle in the path of the remote
Resetting the recorder If you observe any of the following symptoms. The unit is plugged in, but the power will not turn on or off. The front panel display is
you can reset the recorder as follows: Press and hold the POWER button for at least five seconds. This will force the unit to power off then turn the unit back
on. Unplug the power cord, wait at least five seconds, and then plug it in again. 67 Reference Specifications General Power requirements Power consumption
) Operating temperature Operating humidity Television system Recording format AC 200-240V, 50/60 Hz 45W 430 X 49 X 350 mm (w x h x d) without foot
4.6 kg 5°C to 35°C 5 % to 90 % PAL I, B/G, I/I, SECAM D/K, K1 colour system PAL DVD Video Recording, DVD-VIDEO HDD (160GB), DVD-ReWritable,
DVD-Recordable, DVD+ReWritable, DVD+Recordable, DVD+Recordable (Double Layer) DVD (4.7GB): Approx. 1 hour (HQ mode), 2 hours (SQ mode), 4
hours (LQ mode), 6 hours (EQ mode) DVD+R DL (8.5GB): Approx. 3 hour (HQ mode), 3 hours 40 minutes (SQ mode), 7 hours 10 minutes (LQ mode), 10
hours 30 minutes (EQ mode) HDD (160GB): Approx. 42 hours (HQ mode), 82 hours (SQ mode), 152 hours (LQ mode), 226 hours (EQ mode) 27MHz MPEG
2 (VBR support) 48kHz Dolby Digital DVD (PCM 48 kHz): 8 Hz to 20 kHz, CD: 8 Hz to 20 kHz DVD (PCM 96 kHz): 8 Hz to 44 kHz More than 100 dB
(AUDIO OUT connector) Less than 0.008% (AUDIO OUT connector) More than 95 dB (AUDIO OUT connector) Aerial input, 75 ohms 1.0 Vp-p 75 ohms,
sync negative, RCA jack x 2 / SCART x 2 0 dBm more than 47 kohms, RCA jack (L, R) x 2 / SCART x 2 4 pin (IEEE 1394 standard) Recording Recording
format Recordable media Recordable time Video recording format Sampling frequency Compression format Audio recording format Sampling frequency
Compression format Playback Frequency response Signal-to-noise ratio Harmonic distortion Dynamic range Inputs AERIAL IN VIDEO IN AUDIO IN DV IN
Outputs VIDEO OUT COMPONENT VIDEO OUT HDMI video/audio Audio output (digital Audio output (optical Audio output (analog output audio) audio)
compatible in order to play it. No solution.
mode to Stereo.
the obstacle. Replace the batteries with new ones.
control and the recorder. The batteries in the remote control are exhausted.
not working. The recorder is not operating normally. .
Dimensions (approx.) Mass (approx.
audio) 1 Vp-p 75 , sync negative, RCA jack x 1 / SCART x 2 (Y) 1.
Advertisement
