Subsequent Use - Philips TT3000 User Manual

English
16
4 As long as it feels comfortable (not painful), increase the setting by
one level within the recommended range for your skin type and
apply one flash for each setting. Do not apply more than one flash on
the same spot.
5 After the skin test, wait for 24 hours and check your skin for
any reaction. If the skin shows reactions, choose the highest setting
that did not result in any skin reaction for subsequent use.

subsequent use

1 Before every treatment, clean the body attachment, light exit
window and metallic frame of Philips Lumea for men.
2 Press the on/off button to switch on the appliance.
Intensity light 1 goes on automatically to indicate that the appliance
,
is switched on at default intensity 1.
Note: It is normal that the appliance and the attachment become warm during use.
3 Start each treatment by selecting the light intensity very carefully,
based on your skin's sensitivity and on how comfortable the
treatment feels.
Your skin may react differently on different days/occasions for a number of
reasons. See section 'Possible side effects and skin reactions' in this chapter
for more information.
4 Press the % button to increase the intensity. To lower the intensity,
press the ^ button.
Every time you press the button, the corresponding intensity
,
light starts to flash. This takes a few seconds.
5 Place the appliance at a 90° angle on the skin so that the body
attachment and the safety ring are in contact with the skin.
Note: It may be difficult to have the safety ring make proper contact with the
skin on certain areas. In that case, you could hold the Lumea for men upside
down, while you press the flash button with your thumb.