Dell Precision T1600 Service Manual page 77

Error Message
Diskette drive 0 seek failure
Diskette read failure
Diskette subsystem reset failed
Drive not ready
Diskette write protected
Gate A20 failure
General failure
Hard-disk drive configuration error
Hard-disk drive controller failure
Hard-disk drive failure
Hard-disk drive read failure
Invalid configuration information-please
run SETUP program
Invalid Memory configuration, please
populate DIMM1
Keyboard failure
Description
memory modules and, if necessary,
replace them.
A cable may be loose or the computer
configuration information may not match
the hardware configuration.
The floppy disk may be defective or a
cable may be loose. If the drive access
light turns on, try a different disk.
The floppy drive controller may be faulty.
No floppy disk is in the drive. Put a floppy
disk in the drive.
The floppy disk is write-protected. Slide
the write-protect notch to the open
position.
One or more memory modules may be
faulty or improperly seated. Reinstall the
memory modules and, if necessary,
replace them.
The operating system is unable to carry
out the command. This message is usually
followed by specific information—for
example, Printer out of paper. Take the
appropriate action to resolve the problem.
The hard drive failed initialization.
The hard drive failed initialization.
The hard drive failed initialization.
The hard drive failed initialization.
The computer configuration information
does not match the hardware
configuration.
DIMM1 slot does not recognize a memory
module. The module should be re-seated
or installed.
A cable or connector may be loose, or the
keyboard or keyboard/mouse controller
may be faulty.
77