Cisco Small Business WAP44 Administration Manual page 45

Configuring the Cisco WAP4410N Wireless-N Access Point
Administration
STEP 3
WAP4410N Wireless-N Access Point with Power Over Internet Administration Guide
- Web HTTPS Access—Enable HTTPS if needed. The default is
Disabled.
- Wireless Web Access—Allow or deny wireless clients to access web-
based utility. The default is Disabled.
• Remote Console—Enable Secure Shell (SSH) to exchange data over a
secure channel between two computers.
- Secure Shell (SSH)—Enable SSH if needed. The default is Disabled.
• SNMP—Simple Network Management Protocol (SNMP) is a popular
network monitoring and management protocol. It provides network
administrators with the ability to monitor the status of the access point and
receive notification of any critical events as they occur on the access point.
To enable the SNMP support feature, click Enabled. Otherwise, click
Disabled. The default is Disabled.
- Contact—Enter the name of the contact person, such as a network
administrator, for the access point.
- Device Name—Enter the name you want to assign to the access point.
- Location—Enter the location of the access point.
- Get Community—Enter the password that allows read-only access to
the access point's SNMP information. The default is public.
- Set Community—Enter the password that allows read/write access to
the access point's SNMP information. The default is private.
- SNMP Trap-Community—Enter the password required by the remote
host computer that will receive trap messages or notices sent by the
access point.
- SNMP Trusted Host—You can restrict access to the access point's
SNMP information by IP address. Enter the IP address in the field
provided. If this field is left blank, then access is permitted from any IP
address.
- SNMP Trap-Destination—Enter the IP address of the remote host
computer that will receive the trap messages.
Click Save.
6
45