Seagate Ultra160 Product Manual page 255

SCSI Interface Product Manual, Rev. B
[5] The PAGE CODE allows the initiator to select one or all of the pages of Mode parameters supported by
the target. Page codes that may be supported by the drive are summarized here (see individual drive's
Product Manual, Volume 1):
Page Code Description
00h REUNIT ATTENTION Page parameters (returned last of the pages)
01h Error Recovery parameters
02h Disconnect/Reconnect Control parameters
03h Format parameters
04h Rigid Drive Geometry parameters
07h Verify Error Recovery page parameters
08h Caching Parameters page
0Ah Control Mode page
0Ch Notch page
0Dh or 1Ah Power Condition page (see individual drive's Product Manual, Volume 1, for code used)
10h Xor Control Mode page
19h Port Control Mode page
1Ch Informational Exceptions Control page
3Fh Return all supported pages
[6] The ALLOCATION LENGTH specifies the number of bytes that the initiator has allocated for returned
MODE SENSE data. An ALLOCATION LENGTH of zero indicates that no MODE SENSE data shall be
transferred. This condition shall not be considered as an error. Any other value indicates the maximum
number of bytes that shall be transferred. The drive shall terminate the DATA IN phase when ALLOCA-
TION LENGTH bytes have been transferred or when all available MODE SENSE data has been trans-
ferred to the initiator, whichever is less.
[7] See Table 61, "CONTROL field," in Section 7.2.1.
237