Automatic Ice Maker; Removing Ice Maker Storage Bin - Whirlpool ED22ZR Use & Care Manual

Lower
signal
arm to
start it.
Raise
signal
arm to
stop ice.
Automatic
ice
maker
Here are a few things you will want to know
about your automatic ice maker:
l
The ON/OFF lever is a wire signal arm.
Down.. .for making ice automatically.
Up...to shut off the ice maker.
NOTE:
Do not turn ice maker on until it is
connected to the water supply. Instructions for
ice maker water supply hook-up are attached
to the back of the refrigerator cabinet.
l
It is normal for ice crescents to be attached by
a corner. They will break apart easily.
l
The ice maker will not operate until the freezer
is cold enough to make ice. This can take
overnight.
l
If ice is not being made fast enough and more
ice is needed, turn the Refrigerator Control
toward a higher number. Wait a day and, if
necessary, turn the Freezer Control toward C.
l
Good water quality is important for good ice
quality. It is not recommended that the ice
maker be connected to a softened water
supply. Water softener chemicals such as salt
from a malfunctioning softener can damage the
ice maker mold and lead to poor quality ice. If a
softened water supply cannot be avoided, then
it is important that the water softener be well
maintained and operating properly.
Removing ice maker storage bin
Remove, empty and clean the storage bin:
l
If the ice dispenser has not, or will not, be used
for a week or more.
l
If a power failure causes ice in the bin to melt
and freeze together.
l
If the ice dispenser is not used regularly.
1. Pull the covering panel out from the bottom
and slide it to the rear.
11