Advertisement
Led PCB replacement:
1
1
2 2
3 3
4 4
1 1
Four screws need to be removed from
each side of the grill (eight screws total)
using the phillips head screwdriver.
2 2
Keep the eight screws in a safe place.
3 3
Carefully begin to remove the grill. Do
not fully remove the grill as the cable
is still fi rmly attached to the led PCB
assembly. A fl at head screwdriver may
aid in loosening the grill from the cabinet.
5 5
6 6
4 4
Carefully remove the cable attached to
the led PCB assembly.
7 7
8 8
5 5
Use the phillips head screwdriver to
remove one screw near the center of
the led PCB assembly.
6 6
Carefully remove the led PCB assembly
from the back side of the grill.
7 7
The hard part is done, the rest is easy!
Place the new led PCB assembly (part
#0007334) where the old one was. Follow
the same steps as above, but backwards
6 to 1. Power up the SA1530z and the led
should light up. Congratulations, you just
replaced an led PCB assembly...now go
play some shows!
3
Advertisement
