US Electronics UTV86X-E User Manual

TM
User's Guide If you have a TV with a remote
control, we recommend that you
for the
plug its power cord directly into
a wall outlet if available (your
UTV86X-E
cable installer may select an
featuring Memory Lock™
alternate setup).
2-in-1 Cable TV
Remote Control Make sure to set your TV to
channel 2, 3, or 4 as directed by
your cable company.
© 1997 US Electronics Components Corp.
All rights reserved
Part Number USE17095, RC9600/9640
rev 1.1 9701

before you begin

Take note of the buttons that you'll

install batteries

OPEN

important note

Weak batteries may disrupt normal
operation of the remote
We recommend that you use only AA alkaline batteries.
Remotes without the Memory Lock™ feature may need to be reprogrammed when the batteries are removed.
See the troubleshooting section for more info.

setting up your remote control

for your remote-controlled television
use to setup your remote control
step 1
step 2
step 3
setup
the "check all codes" method
FWD
Follow the steps outlined in this section if you've been unable to determine the
VOL
correct code for your TV. This method "hunts" through all possible codes in the
remote until it finds the code for your remote-controlled TV.
PATENT PENDING
1. Manually turn ON your TV set.
2. Point the remote control at the TV and press the following sequence of
TM
3. Press [MENU], [TV POWER], [FAV], and [TV POWER] to check the next
4. Repeat pressing [FAV], followed by [TV POWER], until the TV turns OFF.
Make sure your TV is on. Press the [MENU] button, then
the [TV POWER] button.
Enter the three-digit code for your television from the
"television codes" chart on the back of this sheet.
At this point you have two options depending on whether
you want volume to be controlled through your cable box
or through your TV:
option 1: If you want volume to be controlled through
your cable box, press [POWER].
option 2: If you want volume to be controlled through
your TV, press [TV POWER].
Press the [TV POWER] button. If your TV turns on and
test
off, you're all done. If your TV doesn't turn on and off,
your
perform steps 1 through 3 again with the next available
code for your TV brand. If none of the codes listed for
your TV work, try the "check all codes" method below.
keys: [MENU], [TV POWER], [0], [0], [0], and [TV POWER]. If the TV turns
OFF, congratulations – you're all done. If the TV is still ON, continue at
step 3 below.
code. If the TV turns OFF, press [SELECT] to exit this procedure. If the TV is
still ON, continue at step 4 below.
When the TV turns OFF, press [SELECT] to save the code.
Please be patient: there are about 90 possible codes.