Advertisement
2
MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection
on fitting supplies are 3/8" compression. Connect left supply
(Marked with a Red Stripe) to Hot and right supply (Marked with
Blue Stripe) to Cold wall supply. Use adjustable wrench to
tighten connections. Do not over tighten.
Faucet supplies are 27-1/2" long from faucet base.
Note: If additional supply length
is required, installer must
purchase additional parts
separately.
Important: If SUPPLY HOSES
(1, 2) are too long, loop as
illustrated to avoid kinking.
3 3
TEST INSTALLED FAUCET
Move HANDLE (1) into "off" position.
Unthread SPRAY END (2) from HOSE END (3).
Turn on water supplies and check connections for leaks
Operate HANDLE (1) on and off, hot and cold to flush water
lines thoroughly. Replace SPRAY END (2).
Check all drain connections for leaks.
Move HANDLE (1) to "off" position.
R E D
S T R I P E
.
3
2
HOT & COLD SUPPLIES
B L U E
S T R I P E
2
1
COLD
HOT
M 9 6 8 5 7 7 R e v . 1 . 1
1
Advertisement
